Product name: K11 waterproof slurry (universal type)
Product features: no cracking in thick coating, no emptying in tiling, no swelling in long-term soaking
Guangzhou Meikeshi Waterproof Building Material
Net content: powder 13.2kg + liquid 4.8L
Product introduction: Meikeshi K11 waterproof slurry (universal type) is a two-component cement-based waterproof coating, which is composed of polymer emulsion, high-quality cement and fine active chemical filler.
Product features: simple construction, high bonding strength, surface tiles do not fall off, strong impermeability.
Scope of application: kitchen, bathroom, basement, sink, warehouse, etc.
Construction procedure: base surface treatment → paint mixing → brushing → curing
Base surface treatment: clean up the base surface, and it should be flat and firm, without empty drums. Pore trachoma must be filled and leveled with cement mortar. If the temperature is high or the base surface is dry, it should be fully wetted with clear water before construction.
Coating stirring: Pour the liquid into a clean mixing bucket, and then slowly add the powder while stirring in proportion, and then fully stir to a uniform paste-free, non-precipitating paste. Leave it for a few minutes and then slightly Ready to use (it is recommended to use an electric stirrer for better results).
Brushing: Brush the treated base surface with a hair brush or roller, and do not leak the brush. When painting, if there are pores, you should repeatedly brush to expel the gas. After painting, once the surface is dry (the surface is not sticky to your hands), apply it twice in succession. No more than 1mm, to avoid unnecessary cost waste.
Maintenance: After spraying for 8 hours, spray with fine mist water for curing. At least 24 hours, perform a water-closing test (the temperature should be delayed when the temperature is low or the ventilation is poor).
Note: Please read the package instructions carefully before use. Do not apply under 5 ℃ or in the presence of water or rain. The stirred slurry should be used up within 2 hours. Do not add water and stir before use. Where the air is too humid or not ventilated, ventilation equipment should be used to speed up the waterproof layer to dry. If tiles are to be pasted on the wall, use Mikas special tile adhesive to avoid hollowing or falling off.
The flat base surface is 1.5 ~ 2kg / m2 (based on the actual situation)
Executive standard: JC / T984-2011
Product packaging: powder 13.2kg + liquid 4.8L
Guangzhou Nafiyode Building Material Co., Ltd.